UNIVERSAL SABRA TOOLS
|
ST2 Universal Double Support The ST2, consisting of two 3/8'' and 5/8" male thread devices and one articulated 3/8'' and 5/8" female thread support, all sliding on a 20 cm long hexagonal rod, allows the mounting of two microphones on the same stand, with variable distance and angulation between them. |
 ST2 Universal Double Support |
 ST4 Universal Multiple Support |
ST4 Universal Multiple Support The ST4 accommodates 4 microphones on one stand with 3/8" and 5/8" threaded ferrule and counter-nut, each sliding into any position on a 30 cm long hexagonal black anodized aluminum bar. In the center is a strong serrated swivel, allowing for 180 degrees of rotation. The other extremity of the articulation has a 5/8" internal thread, universally adaptable to most commercially available microphone stands. |
STX Custom Mount
Black anodized hexagonal support bars can be ordered in various lengths:
| 45mm |
$9
|
| 100mm |
$10
|
| 150mm |
$11
|
| 200mm |
$12
|
| 300mm |
$13
|
| 1000mm |
$25
|
| Sliding mic mounts, 3/8" and 5/8" O.D. threaded studs |
$8.50
|
| 5/8" I.D. mic stand mount for hex rods |
$9.75
|
In audio signal capturing by microphones, there is a penetration of unwanted mechanical noises through the microphone stand, caused by vibrations on stage, by the kick drum, by low frequencies of the amplifier, by the artist's coreography on stage, etc. One of the conventional solutions is to adopt electronic recourses, such as noise gate reduction, re-equalization (shut down of low frequencies), etc. Thus, we are interfering with the signal's dynamics, reducing our system's head room, consequently harming the signal's quality and naturalness. The SSM-1 Shockmount is rooted in the following philosophy: "For acoustic problems, acoustic solutions."
Physically isolating the microphone from its stand, the SSM-1 succeeds in filtering the undesirable noises to an extent of approximately 15 dB and at a very low cost. Its mounting versatility and adjustability makes it compatible with most microphone sizes and types availble on the market. For the correct mounting of the microphone, just weave it through the parallel rubber bands of each ring, two by two. Suitable for any microphone shape (tubular or conical) up to 2" diameter. The central articulated support can be fixed anywhere on the hexagonal rod, to compensate for any imbalance of the mic's center of gravity.
 ST2 Double Support with Shockmounts |
 SSM-1 Shockmount |
SPF Pop Filter
 SPF Pop Filter with SSM-1 Shockmount |
 SPF Pop Filter |
